Filter
Top Products
model name1[MZ-RH710] model name2[MZ------]
[2-593-568-11(2)]
masterpage:Right
filename[E:\SONY
PA\5252_RH710\REVISE\DATA\J9050645_2593568112RH710_GB\2593568112\01GB
-MZ-RH710EE\04GB0OPE.fm]
77
CANNOT SET • You tried to make the “Time Mark” setting during synchro-recording.
• You selected “REC Level” while the recorder is not in recording-pause.
, Set “REC Level” while the recorder is in recording-pause.
• You tried to make the following settings while recording.
— Disc Memory
— Play mode
— Recording mode
— Selection of “ :REC” in menu
DATA SAVE • The recorder is writing information to the system file, such as the
recorded data or editing information.
, Wait until the message disappears from the display.
DC IN TOO
HIGH
• Voltage of the power supply is too high (The recommanded optional AC
power adaptor is not used).
, Use the recommanded (optional) AC power adaptor.
DISC FULL • Recording may not be done if the remaining recordable time on the disc
is 48 seconds or less.
, Replace the disc.
D-L READY • MD Simple Burner is now ready to record an audio CD to the disc in the
recorder using Simple mode (see “Software Operation”).
EJECT DISC OK • The recorder has finished communicating with the computer and it is safe
to eject the disc from the recorder or disconnect the dedicated USB cable.
END • The recorder reached to the end of the disc while playing or pressing
>.
ERROR • There is an internal malfunction in the system.
, Restart the operation by doing steps 1 to 3 on page 75.
ERROR XX • There is an internal malfunction in the system.
, Restart the operation by doing steps 1 to 3 on page 75. If the message
appears again, please consult your nearest Sony dealer.
FORMAT
ERROR DISC
• A disc with a format that the recorder does not support was inserted.
, Insert a disc used in Hi-MD mode.
• A disc formatted on the computer was inserted.
, When formatting a disc on the computer, make sure to use the
SonicStage software.
GROUP FULL • You tried to create a 256th group on a disc used in Hi-MD mode or 100th
group on a disc used in MD mode.
, You can create only up to 255 groups (on a disc used in Hi-MD
mode) or 99 groups (on a disc used in MD mode) on a disc. Keep the
group number within 255 or 99.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder (page 16).
LOW BATTERY • Battery is weak.
, Replace the dry battery (page 16).
MEMORY
OVER
• You tried to record with the recorder placed where it receives continuous
vibration.
, Put the recorder on a stable place, and start recording again.
Message Meaning/Remedy
020REG.book Page 77 Tuesday, April 12, 2005 11:18 AM