Filter
Top Products
68
Messages
If the following messages flash in the display window, check the
messages below.
The messages appear on the display window on the remote control
are shown in the parentheses.
BLANKDISC (– – – – – )
• An MD with no recording on it is inserted.
DISC ERR (– – – – – )
• The disc is damaged or does not contain proper recording or editing
data.
— Reinsert the disc. If this fails, rerecord.
DISC FULL (– – – – – )
• There is no more space to record on the disc (page 63).
— Replace the disc.
Data Save (– –)
• The MD player is recording information (sounds) from the memory
to the disc.
— Wait until this process is completed. Do not expose the player to
any physical shock, nor disrupt power supply.
TOC Edit (– –)
• The MD player is recording information (track start and end
position) from the memory to the disc.
— Wait until this process is completed. Do not expose the player to
physical shock, nor disrupt power supply.
BUSY (– – – – – )
• You tried to operate the recorder while it was accessing the
recorded data.
— Wait until the message goes out (in rare cases, it may take 2 - 3
minutes).
NAME FULL (– – – – – )
• You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1700 letters for track or disc
names.
— Enter the characters within the limit.