Filter
Top Products
27
2 Press <SELECT, repeatedly until “SYNC REC” flashes in
the display, and then press ENTER.
“SYNC” does not appear if optical cable is not connected to the
recorder.
3 Press <SELECT, repeatedly until “SYNC ON” flashes in the
display, and then press ENTER.
4 Press and slide REC to the right.
The recorder stands by for recording.
5 Play the source sound.
The recorder starts recording when it receives the playing sound.
To stop recording, press x.
z
• You cannot pause manually during synchro-recording.
• When there is no sound from the player for more than 3 seconds during
synchro-recording, the recorder goes into the standby mode automatically.
When the sound comes from the player again, the recorder resumes synchro-
recording. If the recorder is kept in the standby mode for 5 minutes or longer,
the recorder stops automatically.
• For longer recording, follow step 1 of “Long-time recording (MDLP)”
(page 25) to select the recording mode, and then do the procedure of synchro-
recording.
Notes
• Do not change the “SYNC REC” setting while recording. Recording may not
be done properly.
• Even when there is no recorded sound on the sound source, there may be
cases when recording does not pause automatically during synchro-recording
due to the noise level emitted from the sound source.
• If a silent portion is encountered for 2 seconds or more during synchro-
recording from a sound source other than a CD or an MD, a new track mark
is automatically added at the point where the silent portion ends.
SYNC REC
SYNC indicator