Filter
Top Products
66
• The disc is damaged or does not contain proper recording or editing
data.
— Reinsert the disc. If this fails, rerecord.
“NO SIGNAL” appears in the display when recording from
a portable CD player.
• There is no digital signal from the portable CD player.
— When recording digitally from a portable CD player, use AC
power adaptor and disable the anti-skip function (such as ESP)
on the CD player (page 16).
There is no recording on the MD after a recording
operation.
• The AC power adaptor was unplugged or a power outage occurred
during recording.
The lid does not open.
• The power sources have been disconnected during recording or
editing, or the battery have been exhausted.
— Set the power sources again, or replace the exhausted battery
with new ones.
No sound comes through the headphones/earphones.
• The headphones/earphones plug is not firmly connected.
— Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i.
• Volume is too low.
— Adjust the volume by pressing VOL +/–.
Volume cannot be turned up.
• AVLS is on.
— Set AVLS to “AVLS OFF” (page 40).
An MD is not played from the first track.
• Disc playing stopped before it came to the last track.
— Press . repeatedly to go back to the beginning of the disc,
and restart playing after checking the track number in the
display.
Playback sound skips.
• The recorder is placed where it receives continuous vibration.
— Put the recorder on a stable place.
• A very short track may cause sound to skip.