Sony MZ-R700PC MiniDisc Player User Manual


 
56
Troubleshooting
Should any problem persist after you have made these checks,
consult your nearest Sony dealer.
The recorder does not work or works poorly.
Audio sources may not be firmly connected.
Disconnect the audio sources once and connect them again
(pages 14, 23).
The HOLD function is turned on (HOLD appears in the display
when you press an operation button on the recorder).
Disable HOLD by moving the HOLD switch in the opposite
direction of the arrow (pages 12, 38).
Moisture has condensed inside the recorder.
Take the MD out and leave the recorder in a warm place with the
lid open for several hours until the moisture evaporates.
The rechargeable battery or dry battery is weak (r or LOW
BATT flashes).
Charge the rechargeable battery or replace the dry battery
(page 50).
The rechargeable battery or dry battery have been inserted
incorrectly.
Insert the battery correctly (page 11).
You pressed a button while the disc indication was rotating quickly.
Wait until the indication rotates slowly.
The analog recording was made using a connecting cord with an
attenuator.
Use a connecting cord without an attenuator (page 23).
While operating, the recorder received a mechanical shock, too
much static, abnormal power voltage caused by lightning, etc.
Restart the operation as follows.
1 Disconnect all the power sources.
2 Leave the recorder for about 30 seconds.
3 Connect the power source.
The disc is damaged or does not contain proper recording or editing
data.
Reinsert the disc. If this fails, rerecord.