Filter
Top Products
Editing Recorded MDs
masterpage:Left
(3 column)
filename[D:\Data Folder\sem\4238553111MDSJE480CEL\GB05OPE-CEL.fm]
model name1[MDS-JE480]
[4-238-553-11(1)]
17
GB
To clear the last entered track
Press CLEAR to erase the track number.
To enter a track number over 10
Use >10. See this page for details.
3
Repeat step 2 to enter other tracks.
4
Press N.
Programme Play starts.
To stop Programme Play
Press x.
To check the total of programme
tracks
While the deck is stopped and the “PGM” lights
up, press LEVEL/DISPLAY/CHAR repeatedly.
To check the contents of the
programme during Programme Play
Turn AMS (press
./>
repeatedly).
To add a track to the end of the
programme
Do steps 2 above while the deck is stopped.
To erase all tracks in the programme
Press CLEAR repeatedly until all the track
numbers disappear.
To resume normal play
Press PLAY MODE repeatedly until “PGM”
turns off.
The programme remains even after
Programme Play ends or is stopped
Press
N
to play the programme again.
Notes
• If you eject the MD, the programme will be lost.
• The display shows “---m--s” when the total
playing time of the programme exceeds 1,000
minutes.
• “Step Full!” appears when you try to programme the
26th track.
Editing Recorded MDs
Before editing
You can edit an MD only when:
• The MD is recordable.
• The MD play mode is normal play.
To cancel the last edit
Use Undo Function to cancel the last edit and
restore the contents of the MD to the condition
before the edit.
To quit while editing
Press MENU/NO or x.
When “Tr Protected” appears
in the display
You cannot perform editing operations on
protected tracks (tracks checked out from a
USB connected computer using the Net MD
function, etc.) other than “Moving recorded
tracks” (page 21) and “Naming a track or an
MD” (page 21) using the deck.
After editing
Press EJECT A to remove the MD or press
?/1 to turn off the deck.
“TOC” or “TOC Writing” starts flashing. The
TOC is updated and recording is completed.
Before disconnecting the AC power
cord
MD editing is completed when the MD Table of
Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the deck. Do not disconnect the AC
power cord before updating the TOC (while
“TOC” is lit) or while updating the TOC (while
“TOC Writing” is flashing) to ensure a
complete editing.