Filter
Top Products
masterpage:Left
(3 column)
filename[D:\Data Folder\sem\4238553111MDSJE480CEL\GB05OPE-CEL.fm]
model name1[MDS-JE480]
[4-238-553-11(1)]
14
GB
Synchro-recording with a Sony CD
player (continued)
4
Press CD-SYNCHRO STANDBY on the
remote.
The CD player changes to play standby and
the MD deck changes to recording standby.
5
Press CD-SYNCHRO START on the
remote.
The deck starts recording and the CD player
starts to play.
The track number and elapsed recording
time of the track appear in the display.
If the CD player does not start
playing
Some CD players may not respond when you
press CD-SYNCHRO START on the remote.
Press X on the CD player’s remote instead to
start play on the CD player.
Operations you may want to do
during CD Synchro-recording
Tips
• You can use the remote of the CD player during CD
Synchro-recording
• During CD Synchro-recording, track numbers are
marked in the following ways:
— When the CD player is connected to the
DIGITAL IN connector, track numbers are
automatically marked as they appear on the CD.
— When the CD player is connected to the
ANALOG IN jacks, track numbers are
automatically marked when “T.Mark LSyn” has
been selected (page 10).
— When you resume recording after recording
pause, a new track number is automatically
marked, regardless of the track marking
parameter setting (“T.Mark LSyn” or “T.Mark
Off”).
• By reprograming the MD’s remote, you can use the
procedure above to perform synchro-recording with
a Sony video CD player.
Press 2 while holding down ?/1 on the remote.
Now you can operate both the MD deck and the
video CD player. To select the remote original
function, press 1 while holding down ?/1 on the
remote.
Notes
• When performing CD Synchro-recording with a CD
player with a mode selector, be sure to set the
selector to CD1.
• When you record tracks from certain CD or multi-
disc players, the entire material may be recorded as a
single track.
To Press
Stop recording CD-SYNCHRO STOP on
the remote
Pause recording CD-SYNCHRO STANDBY
on the remote
Resume recording after
pausing
CD-SYNCHRO START on
the remote
Check the remaining
recordable time on the
MD
DISPLAY on the remote
(page 12)
Press To change the
deck to
And change the
CD player to
H Recording Play
x Recording pause Stop
X Recording pause Pause