Filter
Top Products
23
To Press
Check the CHECK on the remote
program repeatedly. After the last
track, “CHECK END”
appears.
Clear a track from CLEAR on the remote in
the end stop mode.
Clear a specific CHECK on the remote
track repeatedly until the
number of the track to be
erased appears, then press
CLEAR.
Add a track to the 1 Press one of the DISC
program 1 – 3 buttons or DISC
SKIP to select a CD.
2 Select the track by
turning the jog dial.
3 Press ENTER/NEXT.
Clear the entire p once in stop mode or
program twice while playing.
Tips
•The program you made remains in the CD player
even after it has been played back. Press CD (P
to play the same program again.
• If the total playing time does not appear during
programming, this means:
– you have programmed a track number
which exceeds 20, or
– the total playing time has exceeded 100 minutes.
•“FULL” appears when you try to program over 32
tracks.
6 To program additional tracks,
repeat steps 3 to 5.
Skip step 3 to select tracks from the same
disc.
7 Press CD (P (or CD ( on the
remote).
All the tracks play in the order you
selected.
To cancel Program Play
Press PLAY MODE repeatedly until
“PROGRAM” or “SHUFFLE” disappears
from the display.