Filter
Top Products
Getting Started
15
xLFE
• LFE
*****
: (0 dB)
Level of the LFE (Low Frequency Effect)
channel output.
Range: OFF, –20 dB to 0 dB, 1 dB steps
“OFF” cuts the sound of the LFE channel.
However, the low frequency sound of the
speakers are output from the sub woofer.
“–20 dB” to “0 dB” settings allow you to
attenuate the LFE signal. “0 dB” outputs the
full LFE signal at the mix level determined by
the recording engineer.
xD.COMP.
• D.COMP.: (STD)
Dynamic range compression.
Range: OFF, 0.1 to 0.9, STD, MAX
“OFF” does not compress the dynamic range.
“0.1” to “0.9” settings allow you to compress
the dynamic range in small steps. “STD”
reproduces the sound track with the dynamic
range intended by the recording engineer.
“MAX” provides a great compression of the
dynamic range.
x T.TONE (MHC-DP1000D only)
• T.TONE: (OFF)
Test tone output.
Range: OFF, ON
“ON” outputs the test tone from each speaker in
sequence. Adjust the LEVEL and BALANCE
parameters so that the volume level of the test
tone from each speaker sounds the same using
the remote from your listening position. Select
“OFF” to turn off the test tone.
Notes
• When you adjust the level of the subwoofer, set
T.TONE to “OFF”.
• Dynamic range compression is possible with Dolby
Digital sources only.
• If you press SPEAKER LEVEL while adjusting
parameters using OSD, the OSD turns off.
Setting the time
1 Turn on the system.
2 Press CLOCK/TIMER SET.
When you set the time for the first time,
proceed to step 5.
3 Press . or > repeatedly to select
“CLOCK SET”.
4 Press ENTER.
5 Press . or > repeatedly to set the
hour.
6 Press ENTER.
7 Press . or > repeatedly to set the
minutes.
8 Press ENTER.
Tip
If you have made a mistake or want to change the
time, start over from step 2.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.