Filter
Top Products
36
8 Press ENTER.
The type of timer (DAILY 1 or DAILY 2),
followed by the start time, stop time and
the music source, appears, then the
original display appears.
9 Turn off the power.
To check the setting
Press CLOCK/TIMER SELECT and press
. or > repeatedly to select the
respective mode (DAILY 1 or DAILY 2), then
press ENTER on the remote.
To change the setting, start over from step 1.
To cancel the timer operation
Press CLOCK/TIMER SELECT and press
. or > repeatedly to select “TIMER
OFF”, then press ENTER.
Notes
•You cannot activate DAILY 1 and DAILY 2 timer
at the same time.
•You cannot set timer if the timer on and off times
are the same.
•When you use the Sleep Timer, Daily Timer and
Timer recording will not turn on the system until
the Sleep Timer turns it off.
•You cannot activate Daily Timer and Timer
recording at the same time.
Tip
The power turns on 15 seconds before the preset
time.
4 Press . or > repeatedly to
select “DAILY 1 (or 2)”, then press
ENTER.
“ON” appears and the hour digits flash
in the display.
5 Set the time to start playback.
Press . or > repeatedly to set the
hour, then press ENTER.
The minute indication starts flashing.
Press . or > repeatedly on the
remote to set the minute, then press
ENTER.
The hour indication flashes again.
6 Set the time to stop playback
following the above procedure.
7 Press . or > repeatedly until
the music source you want appears.
The indications change as follows:
t TUNER y CD PLAY T
t TAPE PLAY T
Waking up to music (continued)
1
1