Filter
Top Products
Other Information
52
Programming the
Remote Control
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to
control with the TV’s remote control, use the following procedures to
program the remote control.
Turn to “Manufacturer’s Codes” on page 53, and find the three-digit
code number for the manufacturer of your component. If more than
one code number is listed, use the number listed first to complete the
following procedure.
1 Move the slide switch to the desired component type (KV-32FV26
and KV-36FV26 models only). (Skip this step if you are
programming a cable box or satellite receiver.)
2 Press CODE SET.
3 Press the function button for the type of component you want to
control with the TV’s remote control (VTR/DVD or SAT/
CABLE).
4 Enter the three-digit manufacturer’s code number.
5 Press ENTER.
6 To check if the code number works, aim the TV’s remote control
at the component and press the green POWER button that
corresponds with that component. If it responds, you are done. If
not, try using the other codes listed for that manufacturer.
Sony
Equipment
Switch Position
on Remote Control
Programmable
Code Number
Beta, ED Beta VCRs VTR1 303
8 mm VCR VTR2 302
VHS VCR VTR3 301
DVD Player DVD/MDP 751
✍ The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
✍ You must perform step 3 within 10 seconds of step 2, or you must start
again from step 2.
❑ If more than one code
number is listed, try
entering them one by
one until you come to
the correct code for
your component.
❑ If you enter a new code
number, the code
number you
previously entered at
that setting is erased.
❑ In some rare cases, you
may not be able to
operate your
component with the
supplied remote
control. In this case,
use the component’s
own remote control
unit.
❑ Whenever you remove
the batteries to replace
them, the code
numbers may revert to
the factory setting and
must be reset.
z