Filter
Top Products
Additional information38
GB
Troubleshooting
If you have any trouble with the unit, read the instruction manual once
more and check the following before requesting for repair.
Symptom
The radio does
not accept button
operations.
The power does
not turn on when
POWER ON/OFF
is pressed.
The display is not
operating.
The display is
dim.
The display is
slow.
There is no sound
output.
There is noise,
bad reception or
weak sensitivity.
Cannot complete
direct tuning.
Cannot preset a
station.
Cannot recall a
preset station.
Cause and remedies
The HOLD function is activated.
c Slide HOLD switch in the direction opposite the
arrow (to disappear “-”). (page 32)
Improper installation of batteries. Weak batteries.
c Insert the batteries with correct polarity. Replace
with new batteries.
The AC power adaptor is disconnected.
c Properly connect the AC power adaptor.
Improper installation of batteries.
c Insert the batteries with correct polarity.
Weak batteries.
c Replace with new batteries.
The unit is being used in extremely low temperature
or in high humidity.
c Use the unit under appropriate conditions.
The volume is turned down completely.
c Adjust the volume.
The headphones are plugged in.
c Unplug the headphones.
Improper installation of batteries.
c Insert the batteries with correct polarity.
Weak batteries.
c Replace with new batteries.
Improper tuning or antenna adjustment.
c Adjust tuning and antenna properly.
Weak radio signal.
c Listen to the radio near a window when in a
vehicle or building.
ATT switch is set to ON.
c Set ATT switch to OFF (page 21).
You took more than 10 seconds between button
operations.
c Complete each button operation within 10
seconds.
Incorrect procedure.
c Hold down ENTER and press a number button
(0–9) (page 22).
You pressed an incorrect number button for the
desired station.
c Press the correct number.
The preset setting was accidentally erased.
c Preset the station again (page 22).