Filter
Top Products
15
GB
Listening to the radio
B Listening to the radio
Changing MW Channel Step
The MW channel step differs depending on the area as shown in the table
below. Select the channel step according to your area.
Channel step according to area
Area Channel step
North and South American countries 10 kHz
Other countries 9 kHz
1 Press POWER ON/OFF to turn off the radio.
2 Press DIRECT.
Perform Step 3 within 10 seconds. Otherwise, the unit will return
to the condition prior to Step 2. In this case, repeat from Step 2. In
addition, perform steps after Step 3 within 10 seconds as well.
3 Enter the channel step using the number buttons.
To enter 9 kHz, press 9 and to enter 10 kHz, press 1 and 0.
4 Press EXE to finish operation.
The entered channel step will flash for about
3 seconds and the unit will return to the
clock display.
Two short beeps will be heard when
entering numbers other than “9” and “10”.
In this case, repeat from Step 2 after
returning to the clock display.
1
3
4
2
Changing MW Channel Step