Filter
Top Products
110
GB
You cannot charge the
battery by connecting the IC
recorder to your computer.
• When you connect the IC recorder to a computer which is not
running, the battery will not be charged.
• Even if the computer is on, and the computer is in a mode of
reduced operation (standby or sleep), you cannot charge the
battery.
• “USB Charge” of “Detail Menu” is set to “OFF” in the menu. To
charge the battery using your computer, set it to “ON.”
• Disconnect the IC recorder from your computer and reconnect it.
• Operation is not guaranteed if you use any system requirements
other than those described on page 99.
• When you are listening to the FM radio, you cannot charge the
battery.
The audio is weak or has
poor quality when listening
to the radio.
• The battery is weak. Replace the battery with new one (page 9).
• Move the unit away from the TV.
The picture of your TV
becomes unstable.
• If you are listening to an FM program near the TV with an indoor
antenna, move the IC recorder away from the TV.
You cannot receive FM radio
stations, or a lot of static is
heard.
• The headphones are not connected (the headphone cord is the FM
antenna).
• Connect the headphones to the
i (headphone) jack and extend the
headphone cord.
• “DX/LOCAL” has been set to “LOCAL.” Set it to “DX”
(page 79).
You cannot preset an FM
radio station.
• You have already preset 30 FM radio stations. Erase unwanted
preset stations (page 69).
• “Scan Sensitivity” has been set to “Low(SCAN L).” Set it to
“High(SCAN H)” (page 79).
It takes a long time for the IC
recorder to start.
• If the IC recorder is required to process a large amount of data, it
may take longer for the IC recorder to start. This is not a
malfunction of the IC recorder. Wait until the start-up display
disappears.
Symptom Remedy