Filter
Top Products
24
To stand the player on its side
1 Attach the stand to the screw hole on the
side of the player using the supplied
screw.
2 Place the player on the stand.
Notes
• Use the supplied stand only when you use the
player in an upright position. Do not attach the
stand when you use the player laid flat.
• To move the player, hold the player itself. If you
hold the stand, it may break.
• Do not use the player in an upright position
without attaching the stand. If you do not attach it,
the player will be unstable and may fall over.
Installing the player on the wall
Attach the jack cover (page 23).
Fastening screws are not supplied. You need
to determine the appropriate hanging screws
and/or other necessary hardware needed to
securely and safely fasten the unit to the wall.
Placement of the screws should be at the same
height and should be 3-1/4 in. (80 mm) apart.
The screws or other fasteners should protrude
by 7/32 to 1/4 in. (5 to 6 mm). Please be sure
you have selected fasteners or screws that will
fit in the hanging holes on the bottom of the
unit.
Remove the seals covering the hanging holes.
Hang the player on the screws. Push the
player tightly against the wall.
Note
WHEN YOU DISCONNECT OR CONNECT THE
CORDS, TAKE THE PLAYER DOWN FROM
THE WALL.
3-1/4 in.
7/32 to 1/4 in.
3/16 in.
3/8 in.