Filter
Top Products
If there is a 4-second or longer blank between each track, a
seafch for the beginning of the current or next track during
playback can be done easily.
Press + or - during playback referring to the playback side
indicator (+ or >) on the display.
For example, when _ is pressed while > is displayed,
playback of the next track starts.
Music sensor function may not be able to detect tracks under
the following conditions:
● Blanks of less than 4 seconds between tracks
● Nc)isyblanks
● Long passages of low-end sound
● bw overall recording levels
\ J
.-—
—f--—— —..
.-— — —--, —
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
Insert tapes into deck 1 and deck 2.
Press TAPE DECK1/2 to select
played back first.
Press REV MODE to select 1).
Press 4 ➤ to start playback.
f>layback continues until ■ is pressed.
the deck to be
About cassette tapes
● To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
.O
&
<~
\ +;
&
\
Type 11tape
Tab for side A
detection
slot
/
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to cover
the Type II tape cletection slot.)
● 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
● Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
ENGLISH14