Filter
Top Products
23
GB
Others
CMT-U1.GB.2-683-463-11(1)
Files cannot be played back.
• USB storage media formatted with le
systems other than FAT16 or FAT32 are
unsupported.*
• If you use partitioned USB storage media,
only les on the rst valid partition can be
played.
• Files that are encrypted or protected by
passwords, etc. cannot be played back.
* is system supports FAT16 and FAT32, but some USB
storage media may not support all of these FAT. For
details, see the operation manual of each USB storage
media or contact the manufacturer.
Tuner
Severe hum or noise, or stations cannot be
received. (“TUNED” or “STEREO” flashes on
the display.)
• Connect the antenna properly.
• Find a location and an orientation that
provide good reception, and then set up the
antenna again.
• Keep the antennas away from the speaker
cords, the power cord and the USB cable to
avoid picking up noise.
• Connect a commercially available external
antenna.
• Consult your nearest Sony dealer if the
supplied AM antenna has come o the plastic
stand.
• Turn o nearby electrical equipment.
To change the AM tuning interval
e AM tuning interval is factory-preset to 9
kHz (or 10 kHz, for some areas; this function
is not available on the European model). You
cannot change the AM tuning interval in Power
Saving Mode.
Use buttons on the unit to change the AM
tuning interval.
1
Tune in any AM station, and then turn off
the system.
2
While holding down TUNER/BAND
,
press /
.
All the AM preset stations are erased. To
reset the interval to the factory preset, repeat
the procedure.
To improve tuner reception
Turn o CD player power by using the CD
power management function. By default, CD
power is turned on. You cannot change the
setting in Power Saving Mode.
Use buttons on the unit to turn o CD player
power.
1
Press FUNCTION
repeatedly to select
the CD function, and then turn off the
system.
2
After “STANDBY” stops flashing, press /
while holding down
.
“CD POWER OFF” appears. With CD
player power turned o, disc access time
is increased. To turn on CD player power,
repeat the procedure until “CD POWER
ON” appears.
Continued