Filter
Top Products
38
GB
Use buttons on the unit for the operation.
1 Connect audio cords.
See “Hooking up optional components” on
page 37.
2 Press TV to switch the function to TV.
3 Start playing the connected
component.
1 Connect a digital optical cord.
See “Hooking up optional components” on
page 37.
2 Connect 6 speakers to an AV amplifier
equipped with a decoder.
For the speaker placement, refer to the
operating instructions supplied with the
connected amplifier.
3 Press DVD SETUP in stop mode.
The Setup Display appears.
4 Press < or , repeatedly to select
“AV”, then press ENTER.
5 Press M or m repeatedly to select
“Dolby Digital” or “DTS”, then press
ENTER.
6 Press M or m repeatedly to select “Bit
Stream”, then press ENTER.
7 Press DVD SETUP to turn off the Setup
Display.
8 Switch the output to 5.1 channel Dolby
Digital sound or 5.1 channel DTS
sound.
See “Changing the sound/subtitle/angle” on
page 19.
Note
If “Dolby Digital” or “DTS” is set to “Bit Stream”,
sound is not output from the supplied speakers and
optional headphone does not function.
Listening to audio from a
connected component
Enjoying the 5.1 channel
sound with the optional
amplifier