Filter
Top Products
Troubleshooting
27
GB
If the system still does not operate
properly after performing the above
measures, reset the system as
follows:
1 Unplug the power cord.
2 Plug the power cord back into the wall
outlet.
3 Press ?/1 to turn on the system.
4 Press x, ?/1 and ENTER at the same
time.
5 Unplug the power cord.
6 Plug the power cord back into the wall
outlet, then press ?/1 to turn on the
system.
The system is reset to the factory settings. All
the settings you made such as the preset
stations, clock, and timer are cleared and must
be set again.
Note
You cannot reset the system in the Power Saving
Mode.
Messages
One of the following messages may appear or
flash in the display during operation.
CD
FULL!
You tried to program 26 or more tracks (steps).
NO DISC
There is no CD in the CD tray.
NO STEP
You have cleared all the tracks you programmed.
OVER
You have reached the end of the CD while
pressing M during play or pause.
PUSH STOP
You pressed PLAY MODE/TUNING MODE
during play.
TAPE
CANT EDIT
You tried to use Tape Select Edit for discs
containing over 20 tracks.
NO TAB
You cannot record the tape because the tab has
been removed from the cassette.
NO TAPE
There is no tape in the tape deck.
OPEN
You performed a tape operation with the tape deck
lid not completely shut.