Filter
Top Products
35
Changing the sound and
display settings
The following items can be set:
Set (setting)
•Clock (page 9)
•CT (Clock Time) (page 23)
•Beep — to turn the beeps on or off.
•RM (Rotary Commander) — to change the
operative direction of the controls of the
rotary commander.
— Select “norm” to use the rotary
commamder as the factory-set position.
— Select “rev” when you mount the rotary
commander on the right side of the
steering column.
•English/Spanish/Portuguese/Swedish — to
change the display language to English,
Spanish, Portuguese or Swedish.
Dis (Display)
•Dimmer — to change the brightness of the
display.
— Select “Auto” to dim the display only
when you turn the lights on.
— Select “on” to dim the display.
— Select “off” to deactivate Dimmer.
•Contrast — to adjust the contrast if the
indications in the display are not
recognisable because of the unit’s installed
position.
•D.Info (Dual Information) — to display the
clock and the play mode at the same time (on)
or to display the information alternately (off).
•M.Dspl (Motion Display) — to turn the
motion display on or off.
•A.Scrl (Auto Scroll)*
1
(page 11)
Snd (Sound)
•EQ Tune*
2
(Equalizer tuning) — to adjust the
frquency and volume level of equalizer
curve.
•Front HPF*
2
(High pass filter for the front
pre-output) — to select the cut-off frequency
of the front pre-output.
•Rear HPF*
2
(High pass filter for the rear pre-
output) — to select the cut-off frequency of
the rear pre-output.
•SUB LPF (Low pass filter for the subwoofer
output)*
2
— to select the roll off frequency of
the subwoofer output.
1 Press (MENU).
2 Press M or m repeatedly until the desired
item appears.
Each time you press m, the item changes as
follows:
Example
Clock t CT t Beep t RM t English/
Spanish/Portuguese/Swedish t D.Info t SA
t Dimmer t Contrast t M.Dspl t A.Scrl*
1
t EQ tune*
2
t Front HPF*
2
t Rear HPF*
2
t
SUB LPF*
2
*
1
When no CD or MD is playing, this item will
not appear.
*
2
CDX-M700R only
Note
The displayed item will differ depending on
the source.
Tip
You can easily switch among categories (“Set,“
“Snd,“ “P/M“ (Play Mode) and “Dis“) by
pressing M or m for two seconds.
3 Press , to select the desired setting
(Example: on or off) or press < or ,
repeatedly to select the frequency
(Example: off, 78 Hz or 125 Hz).
For the “Contrast” setting, pressing ,
makes the contrast higher, and pressing <
makes the contrast lower.
4 Press (ENTER).
After the mode setting is completed, the
display returns to normal play mode.