Filter
Top Products
26
Tip
To check the name of the current component,
ensemble or service, press (LIST) repeatedly until
the respective list appears in the display. The name
of the currently selected item flashes.
Changing the display item
When you press (LIST) once, the list selected
last time appears.
Each time you press (LIST), the list changes as
follows:
V
ENS (Ensemble list)
V
SRV (Service list)
V
CMP (Component list)
V
PRS (Preset list)
V
DAB (Cancel)
Automatic updating of the
ensemble list
When you perform the BTM function for the
first time, all the ensembles available in your
area are automatically stored. When you
perform the BTM function again, the contents
of these lists are updated in accordance with
the conditions described on page 25.
An ensemble is added to the respective list
when it is received during Automatic Tuning
or Manual Tuning but is unlisted.
An unlisted ensemble is also deleted from the
respective list when:
•you select an ensemble from the list, but it
cannot be received.
•you perform Automatic Tuning or Manual
Tuning to receive a listed ensemble, service,
or the component, but it cannot be received.
Replacing the services in preset
memories
Press M or m to select “Over Wrt” in step 4,
then press (ENTER).
Adding the services in preset
memories
Press M or m to select “Insert” in step 4, then
press (ENTER).
Erasing the services in preset
memories
Press M or m to select “Delete” in step 4, then
press (ENTER).
Tip
There is another way to preset the service.
After receiving the service, press the number
buttons ((1) to (6)) of the unit until a beep
sounds.
Listening to a DAB
programme
Follow the procedure below to tune in a DAB
programme manually.
You can also store DAB services in the unit’s
memory for instant tuning (see “Presetting
DAB services automatically (BTM)” on page
25).
1 While listening to a DAB programme,
press (LIST) repeatedly until the
Ensemble List appears.
2 Press M or m until the desired ensemble
appears, then press (ENTER).
3 Press (LIST) repeatedly to until the
Service List appears.
4 Press M or m repeatedly until the desired
service appears, then press (ENTER).
5 Press (LIST) repeatedly until the
Component List appears.
6 Press M or m until the desired component
appears, then press (ENTER).