Filter
Top Products
25
Presetting DAB services
automatically — BTM
The BTM (Best Tuning Memory) function picks
out DAB ensembles and automatically assigns
the services within the ensembles to preset
service numbers. The unit can preset up to 40
services. If services have been previously set,
the BTM function operates under the following
conditions:
•If you activate the BTM function while
listening to a preset service, the unit will
store detected services (by overwriting) only
to preset numbers higher than that of the
current present service.
•If you activate the function while listening to
a service that is not preset, the unit will
replace the contents of all preset numbers.
•In both cases above, if the unit detects a
service that is identical to one already preset,
the previously stored service remains
unchanged and the newly detected service is
not preset.
1 While listening to a DAB programme,
press (MENU).
2 Press M or m repeatedly until “BTM”
appears.
3 Press (ENTER).
A beep sounds when the service is stored.
After activating the BTM function, the unit
tunes the service assigned in the preset
memory 1 automatically.
Note
If the unit can only tune in a few services, the BTM
function may not assign services to all the preset
service numbers.
Presetting DAB services
manually
— Manual Preset Memory
You can also preset DAB services manually or
delete a service which is already preset. Note
that up to 40 services (preset either by the BTM
function or manually) can be preset to the
unit’s memory.
1 While listening to a DAB programme,
press (MENU).
2 Press M or m repeatedly until
“PresetEdit” appears, then press
(ENTER).
3 Select the service and the preset number
you want to preset.
1 Press < or , to select the service.
2 Press M or m to select the preset
number.
3 Press (ENTER).
4 Press M or m to select “Over Wrt.”
Each time you press m, the edit command
changes as follows:
B Over Wrt B Insert* B Delete
* “Insert” does not appear if the maximum
number of services (40) is already preset in
memory.
To preset other services, repeat steps 3 and
4.
5 Press (ENTER).