Filter
Top Products
31
Adjusting the volume of
the subwoofer(s)
1 Press (SOURCE) to select a source (tuner,
CD, or MD).
2 Press (SOUND) repeatedly until “SUB”
appears.
3 Press < or , to adjust the volume.
After three seconds, the display returns to
the normal playback mode.
Tip
When you press (VOL) repeatedly to adjust the
volume all the way down, “Sub ATT” appears and
the cutout frequency of the subwoofer is disabled.
Adjusting the frequency of the
subwoofer(s)
To match the characteristics of the connected
subwoofer(s), you can cut out the unwanted
high and middle frequency signals entering
the subwoofer(s). By setting the cut-off
frequency (see the diagram below), the
subwoofer(s) will output only low frequency
signals so you can get a clearer sound image.
1 Press (MENU).
2 Press (MENU) repeatedly until “SUB LPF”
appears.
3 Press (ENTER).
Level
Cut-off frequency
Frequency (Hz)
4 Press < or , to select the desired cut-
off frequency.
The cut-off frequency in the display
changes as follows:
62 y 78 y 99 y 125 y 157 y off
5 Press M or m to adjust the volume.
6 Press (MENU) twice.
After the frequency setting is complete, the
display returns to the normal playback
mode.
Listening to each
programme source in its
registered DSO
— Source Sound Memory (SSM)
Each time you return to the same source, you
can hear the same DSO menu and equalizer
curve registered for that source, even after
changing the programme source or turning the
unit off and then on again.