Filter
Top Products
57
US
BDV-E6100/BDV-E4100/BDV-E3100/BDV-E2100
4-446-733-12(1)
D:\NORM'S JOB\SONY HA\SO130060\BDV-E6100_4100_3100_E2100
(PMRF 06)\4446733121_US (U2)\100ADD.fm
masterpage: Right
Additional Information
An image is not displayed on the
entire TV screen.
t Check the setting of [TV Type] in
[Screen Settings] (page 46).
t The aspect ratio on the disc is fixed.
Color irregularity occurs on the TV
screen.
t If the speakers are used with a CRT-
based TV or projector, install the
speakers at least 0.3 meters (1 foot)
from the TV set.
t If the color irregularity persists, turn
off the TV set once, then turn it on after
15 to 30 minutes.
t Make sure that no magnetic object
(magnetic latch on a TV stand, health
care device, toy, etc.) is placed near the
speakers.
There is no sound.
t The speaker cords are not connected
securely.
t Check the speaker settings (page 40).
There is no sound from the TV via the
HDMI (OUT) jack when using the
Audio Return Channel function.
t Set [Control for HDMI] in [HDMI
Settings] of [System Settings] to [On]
(page 50). Also, set [Audio Return
Channel] in [HDMI Settings] of
[System Settings] to [Auto] (page 50).
t Make sure that your TV is compatible
with the Audio Return Channel
function.
t Make sure that an HDMI cable is
connected to a jack on your TV that is
compatible with the Audio Return
Channel function.
The system does not output sound of
TV programs correctly when
connected to a set-top box.
t Set [Audio Return Channel] in [HDMI
Settings] of [System Settings] to [Off]
(page 50).
t Check the connections (page 20).
Severe hum or noise is heard.
t Move your audio equipment away
from the TV.
t Clean the disc.
The sound loses stereo effect when
you play a CD.
t Select stereo sound by pressing
AUDIO (page 37).
The sound outputs from the center
speaker only.
t Depending on the disc, the sound may
output from the center speaker only.
No sound or only a very low-level
sound is heard from the surround
speakers.
t Check the speaker connections and
settings (pages 18, 40).
t Check the sound mode setting
(page 24).
t Depending on the source, the effect of
the surround speakers may be less
noticeable.
t A 2-channel source is being played.
Distortion occurs in the sound of a
connected equipment.
t Reduce the input level for the
connected equipment by setting
[Attenuate - AUDIO] (page 48).
A sudden loud music is heard.
t The build-in sound demonstration is
activated. Press VOL – to reduce the
volume or press x to stop the
demonstration.
Sound