Filter
Top Products
For example, when the button is pressed while is displayed, playback of the next track starts.
Music sensor function may not be able to detect tracks under the following conditions:
• Blanks of less than 4 seconds between tracks
• Noisy blanks
• Long passages of low-end sound
• Low overall recording levels
TAPE PLAYBACK (cont.) pg. 12
CONTINUOUS PLAY
After playback on one deck finishes, the tape in other deck will start to play without interruption.
1 Insert tapes into deck 1 and deck 2.
2 Press the TAPE/DECK1/2 button to select the deck to be played back first.
3 Press the REV MODE button to select .
4 Press the button to start playback.
Playback continues until the button is pressed.
About cassette tapes
• To prevent accidental erasure, break off the plastic tabs on the cassette tape after recording with a screwdriver or
other pointed tool.
To record on the tape again, cover the tab openings with adhesive tape, etc. (On Type II tapes, take care not to cover
the Type II tape detection slot.)
• 120-minute or longer tapes are extremely thin and easily deformed or damaged. They are not recommended.
• Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam in the