Filter
Top Products
CMT-HX80R.GB.3-452-364-11(1)
29
GB
Others
Play does not start.
Turn o the system and reconnect the
USB device, then turn on the system.
Connect the supported USB device
(page 35).
Press (or USB on the unit)
to start play.
Play does not start from the rst
track.
Set the play mode to Normal Play
mode.
Files cannot be played back.
The audio file does not have the
extension “.mp3”, “.wma”, “.m4a”.
The data is not stored in MP3/WMA/
AAC format.
USB storage device formatted with le
systems other than FAT16 or FAT32
are unsupported.*
If you use a partitioned USB storage
device, only les on the rst partition
can be played.
Playback is possible up to 8 levels.
The number of folders has exceeded
999.
The number of files has exceeded 999.
Files that are encrypted or protected by
passwords, etc. cannot be played back.
* is system supports FAT16 and FAT32, but
some USB storage devices may not support
all of these FAT. For details, see the operation
manual of each USB storage device or
contact the manufacturer.
Tuner
Severe hum or noise, or stations
cannot be received. (“TUNED” or “ST”
ashes on the display.)
Connect the antenna properly.
Find a location and an orientation that
provide good reception, and then set
up the antenna again.
Keep the antennas away from the
speaker cords, the power cord and the
USB cable to avoid picking up noise.
Connect a commercially available
external antenna.
Consult your nearest Sony dealer if the
supplied AM antenna has come o the
plastic stand.
Turn o nearby electrical equipment.
“TUNED” does not appear in the
display (DAB only).
Check all antenna connections, then
perform the DAB Automatic Scan
procedure (page 12).
e current DAB service may not be
available. Press +/ (or TUNE +/
on the unit)
to select a dierent
service.
If you have moved to another area,
some services/frequencies may have
changed and you may not be able
to tune into your usual broadcast.
Perform the DAB Automatic Scan
procedure to re-register the contents of
broadcasts. (Performing this procedure
clears all previously stored presets.)
To improve tuner reception
Turn o CD player power by using the
CD power management function. By
default, CD power is turned on.
1
Press FUNCTION +/ (or FUNCTION
on the unit)
repeatedly to select
the CD function, and then turn o
the system.
2
After “STANDBY” stops ashing, press
/
on the unit while holding
down /CANCEL
on the unit.
“CD POWER OFF” appears. With CD
player power turned o, disc access
time is increased. To turn on CD
player power, repeat the procedure
until “CD POWER ON” appears.
Continued