Sony 3-298-611-11(1) Home Theater System User Manual


 
Control for HDMI/External Audio Device
75
GB
12 Press C/c to select the next operation.
x To finish pairing
Select [NO], then press .
x To perform pairing of another S-AIR
sub unit
Select [YES], then press .
Note
• If you perform the pairing operation between the unit
and another S-AIR sub unit (page 73), sound
transmission established by ID is canceled.
When you perform pairing, [(PAIRING)] appears
beside ID on the display for selecting ID.
To cancel pairing
Perform the ID setting of the unit according to
the procedure of “To set the ID of the unit.” If
you select a new ID (you can select the same ID
as before), pairing is canceled.
If you use multiple wireless systems which
sharing the 2.4 GHz band, such as wireless LAN
or Bluetooth, the transmission of S-AIR
products or other wireless systems may be
unstable. In this case, the transmission may be
improved by changing the following “RF
CHANGE” setting.
1 Press SYSTEM MENU.
2 Press X/x repeatedly until “RF
CHANGE” appears in the front panel
display, then press or c.
3 Press X/x to select the desired setting.
•“AUTO: Normally select this. The
system change “RF CHANGE” to “ON”
or “OFF” automatically.
“ON”: The system transmits sound by
searching the better channel for
transmitting.
“OFF”: The system transmits sound by
fixing the channel for transmitting.
4 Press .
The setting is made.
5 Press SYSTEM MENU.
The system menu turns off.
6 When you set “RF CHANGE” to “OFF,”
select the ID so that sound
transmission is most stabilized
(page 71).
Note
• When the wireless transceiver is not inserted in the
unit, you cannot set the “RF CHANGE.”
• In most cases, you will not need to change this
setting.
• If “RF CHANGE” is set to “OFF,” transmission
between the unit and S-AIR sub unit can be
performed using one of the following channels.
S-AIR ID A: equivalent channel for Wi-Fi
channel 1
S-AIR ID B: equivalent channel for Wi-Fi
channel 6
S-AIR ID C: equivalent channel for Wi-Fi
channel 11
• The transmission may be improved by changing the
transmission channel (frequency) of the other
wireless system(s). For details, refer to the operating
instructions of the other wireless system(s).
If sound transmission is
unstable
For the surround amplifier
For the S-AIR receiver