Filter
Top Products
25
GB
Getting Started
Press AMP MENU, then press
AUTO CAL.
You can also select “A.CAL YES” in the
A. CAL menu.
The following appears on the display.
A.CAL [5] t A.CAL [4] t A.CAL [3] t
A.CAL [2] t A.CAL [1]
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
Note
You cannot measure the speaker height of the
surround speakers. Set this value using “SUR POS.”
parameters in the SYSTEM menu (page 35).
Tip
When Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you do the following during the
measurement process:
–Press ?/1 or MUTING.
– Press input buttons on the remote or INPUT
SELECTOR on the receiver.
– Change the volume level.
– Press AUTO CAL again.
1 Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
Performing Auto Calibration
Measurement for Display
Speaker existance TONE
Speaker gain, distance,
frequency response
T.S.P.
Subwoofer gain and distance WOOFER
123
46
78
0/10
ENTER
9
SYSTEM STANDBY
TV INPUT
SLEEP
DMPORT
VIDEO1 VIDEO2 BD DVD
2CH A.F.D.
RETURN/EXIT
TV CH TV CH
MOVIE MUSIC
AMP MENU
CLEAR
DISPLAY
MUTING
TV VOL
MASTER VOL
DVD/BD
MENU
AUTO CAL
D.TUNING
D.SKIP
THEATRE
SAT TV SA-CD/CD TUNER
?/1
-
O
5
>10
MEMORY
MENU/HOME
TOOLS/
OPTIONS
TV
?/1
AV
?/1
AUTO CAL
Input
buttons
?/1
switch
MASTER
VOL +/–
MUTING
AMP MENU
Confirming/saving the
measurement results
Measurement
result
Display Explanation
When the
measurement
process
completes
properly
SAVE Proceed to step
2.
When the
measurement
process fails
ERROR
XXXX
See “When
error codes
appear” (page
26).
continued