Filter
Top Products
24
GB
Before you perform the Auto Calibration, set
up and connect the speakers (page 11, 14).
• The AUTO CAL MIC jack is used for the
supplied optimizer microphone only. Do not
connect other microphones to this jack.
Doing so may damage the receiver and the
microphone.
• During the calibration, the sound that comes
out of the speakers is very loud. The volume
of the sound cannot be adjusted. Pay
attention to the presence of children or to the
effect on your neighborhood.
• Perform the Auto Calibration in a quiet
environment to avoid the effect of noise and
to get a more accurate measurement.
• If there are any obstacles in the path between
the optimizer microphone and the speakers,
the calibration cannot be performed
correctly. Remove any obstacles from the
measurement area to avoid measurement
error.
Note
If the muting function has been activated before you
perform Auto Calibration, the muting function will
be set to off automatically.
Example: HT-SS1300
1 Connect the supplied optimizer
microphone to the AUTO CAL
MIC jack.
2 Set up the optimizer
microphone.
Place the optimizer microphone at your
listening position.You can also use a stool
or tripod so that the optimizer
microphone remains at the same height as
your ears.
Tip
When you face the speaker towards the optimizer
microphone, you will get a more accurate
measurement.
Before you perform Auto
Calibration
DMPORTVIDEO 1
ACTIVE
STANDBY
VIDEO 2 DVD SAT TVSA-CD/CDTUNER
MASTER
V
OLUME
AUTO CAL MIC
INPUT SELECTOR
PRESET
TUNING
SOUND FIELD
MUTING
BD
?/1
Optimizer
microphone