75
GB
Additional Information
HDMI
The source sound input to the HDMI
jack on the receiver is not output from
the receiver or the TV speaker.
• Check the HDMI connection (page 58).
• You cannot listen to the Super Audio CD
by connecting HDMI.
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
The source image input to the HDMI
jack on the receiver is not output from
the TV.
• Check the HDMI connection (page 58).
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
The Control for HDMI function does not
work.
• Check the HDMI connection (page 58).
• Make sure “CONTROL FOR HDMI” is
set to “CTRL ON” in the VIDEO menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected component. Refer to the
operating instructions of the connected
component.
• Repeat the procedures of “Preparing
Control for HDMI function” if you change
the HDMI connection, connect/disconnect
the AC power cord, or when there is a
power failure (page 59).
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If the TV does not have System Audio
Control function, set the “AUDIO FOR
HDMI” settings in VIDEO menu to
– “TV+AMP” if you want to listen to the
sound from the TV speaker and
receiver.
– “AMP” if you want to listen to the
sound from the receiver.
• If you cannot listen to the sound of a
component connected to the receiver
– Select the appropriate input when you
want to watch a program on a
component connected via HDMI
connection to the receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
The TV’s remote commander cannot be
used to control the connected
component when using the Control for
HDMI function.
• Change the input of the receiver to the
HDMI input connected to the component.
continued