Filter
Top Products
[ Installation ]
21
cabLe instaLLation
Once the antenna is mounted according to the previous instructions, you can continue with
the cable portion of the installation:
Using one of the RG-6 cables you purchased separately, slide the rubber boot over the
cable connection. Attach the cable to the antenna and slide the rubber boot over the
connection to provide a weatherproof seal. Install the cable tie around the cable directly
below the rubber boot to prevent the rubber boot from slipping down. Trim off the
excess cable tie. (Figure 14)
Route the remainder of the antenna cable into the home or building to where you are
locating the Splitter. When routing the antenna cable, be careful not to pinch, squash,
kink, or crimp the cable, or cut, damage, or puncture the external jacket of the antenna
cable.
Connect the cable from the antenna to the IN port on the Splitter. (Figure 15) Note that
you must use the Splitter.
1.
2.
3.
Figure 14Figure 14