Filter
Top Products
ENGLISH
18
LISTENING TO A PROGRAM SOURCE
Operations
Before operation
Select the desired input source.
3
• Enter the standby mode.
• The STANDBY button lights up in red.
This means that the receiver is not
disconnected from the AC mains and a
small amount of current is retained to
support the memorized contents and
operation readiness.
• To switch the power off, push the POWER switch again.
• Then power is cut off and the STANDBY button goes
off.
• Each time the STANDBY button on the front panel or
the POWER button on the remote control is pressed,
the receiver is turned on to enter the operating mode(the
STANDBY button lights up in blue) or off to enter the
standby mode (the STANDBY button lights up in red).
• In the standby mode, if one of the INPUT SELECTOR
buttons is pressed, the receiver is turned on
automatically and the desired input is selected.
• Each time this button is pressed, the speaker mode
changes as follows and the sound can be heard from the
speakers connected to the selected front speaker
terminals:
Front A( ) Front B( )
Off Front A and B( )
• When using the headphones for private listening , select
the Off mode to switch off the front speakers and all the
others.
In the standby mode, turn the power on.
1
Switch the desired front
speakers on.
2
POWER
ON / OFF
POWER
or
INPUT SELECTOR
AUDIO VIDEO
TAPE MON.
OFF
OSD
OFF
OSD
POWER
MAIN
PAGE
FA
V
MUTE
CH/
SET
VOL
RETURN
DISC
DISP
MI
ROOM 2
1
STEREO
7.1
SURR
CH
2
3
4
5
6
7
8
9
0
ENT
M2
M3
AUTO DSP
RNC-500
ON/STANDBY
STANDBY
or
POWER
A/B
SPEAKER
Notes :
Before operating this receiver with the supplied remote control, refer to “ Universal Remote Controls” on page 11 for
details about operation.
Before operating this receiver, first set this unit as desired for optimum performance, by using the OSD menu setting
procedures. (For details, refer to “OSD Menu Settings” on page 35.)
• Each time the “AUDIO” button is pressed, the input
source changes as follows:
PHONO TUNER CD AUX
(frequency display)
• Each time the “VIDEO” button is pressed, the input
source changes as follows:
VIDEO 1 VIDEO 2 ------- VIDEO 5
• When the TAPE MONITOR button is set to on so that
“TAPE MON” lights up, other inputs can not be heard
from the speakers.
To listen to an input source except TAPE MONITOR, be sure
to set the TAPE MONITOR button to off.
TAPE MONITOR function
You can connect either a tape deck or a graphic equalizer to the
receiver’s TAPE MONITOR jacks.
Only when you listen to the component connected to these
jacks, set the TAPE MONITOR button to on.
If you connect a 3-head tape deck, you can listen to the sound
being recorded during recording, and not the source sound.
For further details, refer to the operating instructions of the
connected component.
When selecting the 7.1 CH DIRECT as desired
• Depending on the power amplifier setting for the surround
back channels and the surround back speaker setting, “7.1(,6.1
or 5.1) CH DIRECT” is displayed and the 8(/7/6) separate
analog signals from the component connected to this input
pass through the tone, volume and bass management(if
selected) circuits only and can be heard from your speakers.(In
case that the TAPE MONITOR button is set to on, the TAPE
MONITOR button is automatically set to off.)
• Press the 7.1 CH DIRECT button or select the desired input
source to cancel the 7.1 CH direct function.
• These analog signals can be heard only. They cannot be
recorded.
POWER
or
7.1CH DIRECT
OFF
OSD