Filter
Top Products
E-11
In this example, the clock is set for the 24-hour (00:00)
display.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the (TIMER)/CLOCK button. The time display will
appear for about 5 seconds.
[When the power is on]
Press the (TIMER)/CLOCK button. The time display will
appear for about 5 seconds.
Note:
The “00:00” will appear when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform “Setting the clock” from step 1.
Timer playback:
The unit turns on and plays the desired source (CD, USB,
TUNER or AUDIO IN) at a preset time.
Before setting timer:
Setting the clock (Remote control
only)
1 Press the ON/STAND-BY button to turn to stand-by
mode.
2 Press and hold the (TIMER)/CLOCK button until
“00:00” appear.
3 Within 10 seconds, press the or button to
adjust the hour and then press the MEMORY button.
Press the or button once to advance the time
by 1 hour. Hold it down to advance continuously.
4 Press the or button to adjust the minutes and
then press the MEMORY button. Press the or
button once to advance the time by 1 minute. Hold it
down to advance continuously.
Timer and sleep operation (Remote
control only)
■ Timer playback
1
Check that the clock is set to the correct time (refer to
page 10).
If it is not set, you cannot use the timer function.
2 For timer playback, load the disc to be played back.
1 Press ON/STAND-BY button to turn the power on.
2 Press and hold (TIMER)/CLOCK button for about 2
seconds.
3 Within 10 seconds, press the or button to
select “ONCE” or “DAILY” and then press the
MEMORY button.
4 Press the or button to set hour then press the
MEMORY button.
5 Press the or button to set minute and then
press the MEMORY button.
6 Press the or button to set hour and then press
the MEMORY button.
7 Press the or button to set minute and then
press the MEMORY button.
8 Press the or button to select wake up source
(CD, USB, TUNER, AUDIO IN) then press the
MEMORY button.
When you select TUNER, select a preset station by
pressing the or button, and then press the
MEMORY button. If a station has not been
programmed, timer setting will be canceled.