Sharp XL-UH06H Stereo System User Manual


 
E-3
Battery holder
Remote
control
Plastic
shield
Polarity
(+) symbol
Battery type
Locking tab
Positive (+)
side up
Battery holder
Locking tab
Back of remote
control
Precautions for battery use:
Remove the battery if the unit will not be used for long
periods of time. This will prevent potential damage due
to battery leakage.
Caution:
Do not use rechargeable battery (nickel-cadmium
battery, etc.).
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Batteries (battery pack or battery installed) shall not
be exposed to excessive heat such as sunshine, fire
or the like.
Installing the battery incorrectly may cause the unit to
malfunction.
Notes concerning use:
Replace the battery if the operating distance is
reduced or if the operation becomes erratic. Purchase
“CR 2025”, coin lithium battery.
Periodically clean the transmitter on the remote control
and the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may
interfere with operation. Change the lighting or the
direction of the unit if this occurs.
Keep the remote control away from moisture, heat,
shock, and vibrations.
Note:
Before using remote control, please remove plastic shield
at battery holder.
While pushing the locking tab towards the centre
of the remote control, slide out the battery holder.
Remove the old battery from the battery holder,
insert the new battery and then slide the battery
holder back into the remote control.
1
2
Remote control - battery installation
21W
10
Left speaker
Right speaker
FM aerial
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
Make sure to unplug the AC power lead before making any connections.
The spec label (*)
The spec label illustration
may be different from the
actual label used.
(*)
Label is located at the
bottom of the unit.
System connections (continued)