Filter
Top Products
E-11
Timer playback:
The unit turns on and plays the desired source (CD, USB,
TUNER or AUDIO IN) at a preset time.
Before setting timer:
Note:
This unit will turn on or enter the power stand-by mode
automatically. However, the connected unit will not turn on
or off. To stop the timer playback, follow step "Cancelling
the timer setting" on this page.
Cancelling the timer setting:
Press the (TIMER)/CLOCK button until "ONCE" or "DAILY"
appears and then press MEMORY button. The unit display
shows "OFF".
The radio, compact disc, USB and AUDIO IN can all be
turned off automatically.
Timer and sleep operation (Remote control only)
■ Timer playback
1
Check that the clock is set to the correct time (refer to
page 10).
If it is not set, you cannot use the timer function.
2 For timer playback, load the disc to be played back.
1 Press ON/STAND-BY button to turn the power on.
2 Press and hold (TIMER)/CLOCK button for about 2
seconds.
3 Within 10 seconds, press the or button to
select “ONCE” or “DAILY” and then press the
MEMORY button.
4 Press the or button to set hour then press the
MEMORY button.
5 Press the or button to set minute and then
press the MEMORY button.
6 Press the or button to set hour and then press
the MEMORY button.
7 Press the or button to set minute and then
press the MEMORY button.
8 Press the or button to select wake up source
(CD, USB, TUNER, AUDIO IN) then press the
MEMORY button.
When you select TUNER, select a preset station by
pressing the or button, and then press the
MEMORY button. If a station has not been
programmed, timer setting will be canceled.
9 Adjust the volume using or and then press the
MEMORY button. (Do not turn the volume too high).
10
If “TUNER” is selected, press the MEMORY button to
enter the preset selection mode.
11 To select a preset channel number, press the or
button and then press the MEMORY button.
12 The “ ” or “ DAILY” indicator lights up.
13 Press the ON/STAND-BY button to enter the power
stand-by mode. The TIMER LED indicator light up and
the unit is ready for timer playback.
14 When the preset time is reached, playback will start.
“ ” indicator will blink to show timer playback. The
volume will increase gradually until it reaches the
preset volume level.
15 When the timer end time is reached, the system will
enter the power stand-by mode automatically.
Checking the timer setting:
1
Press and hold down the (TIMER)/CLOCK button
repeatedly to view the TIMER ON and TIMER OFF setting.
■ Sleep operation
1
Play back the desired sound source.
2 Press the SLEEP button.
3 Within 10 seconds, press the SLEEP button repeatedly
to select the time.
90 80 70 ... 20 10