Filter
Top Products
E-10
If any of the following events occur, it does not mean
that the unit is faulty:
● “PS”, “NO PS” and a station name appear alternately,
and the unit does not operate properly.
● If a particular station is not broadcasting properly or a
station is conducting tests, the RDS reception function
may not work properly.
● When you receive an RDS station whose signal is too
weak, information like the station name may not be
displayed.
● “NO PS”, “NO PTY” or “NO RT” will be displayed for few
seconds, and then the frequency will be displayed.
Notes for radio text:
● The first 8 characters of the radio text will appear for 4
seconds and then they will scroll across the display.
● If you tune in to an RDS station which is not
broadcasting any radio text, “NO RT” will be displayed
when you switch to the radio text position.
● Whilst radio text data is received or when the text
contents change, “RT” will be displayed.
To specify programmed types and select stations
(PTY search):
You can search a station by specifying the programme type
(news, sports, traffic programme, etc.) from the stations in
memory.
Notes:
● If the display has stopped flashing, start again from
step 2. If the unit finds a desired programme type, the
corresponding channel number will lit for about 4
seconds, and then the station name will remain lit.
● If you want to listen to the same programme type of
another station, press the RDS PTY button and start
again from step 2. The unit will look for the next station.
In this example, the clock is set for the 24-hour (00:00)
display.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the (TIMER)/CLOCK button. The time display will
appear for about 5 seconds.
[When the power is on]
Press the (TIMER)/CLOCK button. The time display will
appear for about 5 seconds.
Note:
The “00:00” will appear when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform “Setting the clock” from step 1.
Using the Radio Data System (RDS)
(continued)
■ Notes for RDS operation
■ To recall stations in memory
1
Press the FUNCTION button repeatly to select TUNER
function.
2 Press the RDS PTY button on the remote control.
Selected PTY code (blinking) will appear for about 6
seconds.
3 Within 6 seconds, press the or button to select
the PTY code.
Each time the button is pressed, the PTY code will
appear.
4 Whilst the selected PTY code is displayed (within 6
seconds), press the RDS PTY button again.
● The unit searches the all preset stations and stops
when it finds a station of the selected category then
tunes into the stations. The RDS indicator lights up.
● If no programme is found in the all preset stations,
“NO PTY” appear on the display and returns to the
previous station.
Using the Radio Data System (RDS)
(continued)
Setting the clock (Remote control
only)
1 Press the ON/STAND-BY button to turn to stand-by
mode.
2 Press and hold the (TIMER)/CLOCK button until
“00:00” appear.
3 Within 10 seconds, press the or button to
adjust the hour and then press the MEMORY button.
Press the or button once to advance the time
by 1 hour. Hold it down to advance continuously.
4 Press the or button to adjust the minutes and
then press the MEMORY button. Press the or
button once to advance the time by 1 minute. Hold it
down to advance continuously.