Filter
Top Products
23
SD-EX200
03/3/14
SD-EX200_sec.fm
TINSZ0523AWZZ
2
3
4
5
6
7
8
1
Advanced Features
- Timer and sleep operation -
To check the timer setting:
Reusing the memorized timer setting:
The timer setting will be memorized once it is entered. To reuse the same setting,
perform the following operations.
Changing the timer setting:
Tu rn the power on, and repeat the operation from step 2 in "Timer playback" (see
pages 22 - 23).
Canceling the timer playback:
Timer playback is canceled by turning the power on while in the timer playback stand-
by mode. The same operation can be performed in the following procedure without
turning the power on.
Caution:
The contents of the setting will be erased if the unit is unplugged or a power failure
occurs. In such cases, set the timer again.
Notes:
z The timer playback is possible with a CD even if the repeat, random, or pro-
grammed playback is set.
z When performing timer playback using another unit connected to the AUX IN
jacks, select "AUX" in step 9. At this time, only this unit will be turned on or enter
the power stand-by mode automatically. (Another unit will not be turned on or off.)
9
Press the CURSOR ( or ) button to select the desired function
(CD, TUNER or AUX).
10
Press the ENTER button.
When you select the tuner, select a station by pressing the CURSOR ( or
) button, and then press the ENTER button.
If a station has not been programmed, "NO P-SET" will appear.
11
Press the CURSOR ( or ) button to adjust the volume.
Be careful not to turn the volume up too high.
12
Press the ENTER button.
Settings are displayed in order and the
unit will enter the timer stand-by mode.
1While in the timer playback stand-by mode, press the TIMER button.
2Within 10 seconds, press the CURSOR
( or ) button to select "CALL", and
press the ENTER button.
The unit returns to the timer playback stand-by mode after the setting contents
are displayed in order.
When the start time is reached:
Playback starts automatically and the vol-
ume increases gradually.
Timer Play Indicator
The timer playback indicator flashes.
When the finish time is reached:
The unit is set to the power stand-by mode automatically.
1Turn the power on and press the TIMER button.
Set the unit to the correct time if "STANDBY" does not appear.
2Within 10 seconds, press the ENTER button.
After the setting contents are displayed in order, the unit is set to the timer play-
back stand-by mode.
1Press the TIMER button.
"CANCEL" will appear.
2Within 10 seconds, press the ENTER button.
Timer playback will be canceled (the contents of the setting will not be canceled).