Filter
Top Products
14
SD-EX200
03/3/14
SD-EX200_sec.fm
TINSZ0523AWZZ
Preparation for Use
- General control -
General control
To turn the power on
Press the ON/STAND-BY button to turn the power on.
If the power does not turn on, check the AC power cord is plugged in properly.
Note:
When turning on the power right after it is set to the stand-by mode, wait a few sec-
onds.
To change the display brightness (2 levels)
When the power is on, you can switch the display brightness by pressing the DIS-
PLAY button on the remote control.
Volume control
Press the VOLUME (+ or -) button to increase or decrease the volume.
Bass control
Treble control
Surround
Press the SURROUND button to enjoy music that seems to surround you. "SUR-
ROUND" will appear.
To cancel the surround mode, press the SURROUND button again.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
For example, CD function
Dimmer on Dimmer off
1Press the BASS/TREBLE button to select "BASS".
2Within 3 seconds, press the VOLUME (+ or -) button to adjust the bass.
1Press the BASS/TREBLE button to select "TREBLE".
2Within 3 seconds, press the VOLUME (+ or -) button to adjust the treble.
SURROUND indicator "SURROUND" will go out.
21 39 400
.....
+5
-
5
+5
-
5