Sharp CD-MPS600 Stereo System User Manual


 
13
CD-MPS66
CD-MPS600
Preparation for Use
Remote control
! Battery installation
Precautions for battery use:
"
Replace all old batteries with new ones at the same time.
" Do not mix old and new batteries.
"
Remove the batteries if the unit will not be used for long periods
of time. This will prevent potential damage due to battery leak-
age.
Caution:
"
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
"
Installing the batteries incorrectly may cause the unit to malfunc-
tion.
Notes concerning use:
"
Replace the batteries if the operating distance is reduced or if the
operation becomes erratic.
" Periodically clean the transmitter on the remote control and the
sensor on the unit with a soft cloth.
"
Exposing the sensor on the unit to strong light may interfere with
operation. Change the lighting or the direction of the unit.
"
Keep the remote control away from moisture, heat, shock, and
vibrations.
! Test of the remote control
Check the remote control after checking all the connections (see
pages 10 - 12).
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you
can enjoy music.
Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
Batteries are not included.
1 Open the battery cover.
2 Insert the batteries according to the direction indicated in
the battery compartment.
When inserting or removing the batteries, push them toward the
battery terminals.
3 Close the cover.
8" - 20'
(0.2 m - 6 m)
Remote sensor