Filter
Top Products
23
CD-BA250(U)3.fm00/12/4
Tape Recording
- Recording from the Radio -
Recording from the Radio
Before recording:
z
When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
z
SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
z
The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
z
For recording, use only normal tapes. Do not use metal or CrO tapes.
Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback
only.
To interrupt recording:
Press the REC PAUSE ( ) button.
To resume recording, press the / (TAPE 2 ) button.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise while recording an AM station, move the AM loop
antenna.
1
Tune in to the desired station. (See page 20.)
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
3
Press the REC PAUSE ( ) button.
Recording will be paused.
4
Press the / button on the main unit or the TAPE 2 button on
the remote control to start recording.
Erase-prevention tab of cassette tapes:
z
When recording on a cassette tape, make
sure that the erase-prevention tabs are not re-
moved. Cassettes have removable tabs that
prevent accidental recording or erasing.
z
To protect the recorded sound, remove the tab
after recording. Cover the tab hole with adhe-
sive tape to record on the tape without the tab.
Side A
Tab for side B
Tab for side A
Listening to the Radio (See page 20.)