Sharp CD-BA2600 Stereo System User Manual


 
11
CD-BA250(U)2.fm00/12/4
Preparation for Use
- System Connections -
Speaker connection
Connect the black wire to the minus (-) terminal, and the red wire to the plus
(+) terminal.
Caution:
FM/AM loop antenna connection
Connect the FM/AM loop antenna to the ANTENNA jack.
Position the FM antenna wire and rotate the AM loop antenna for optimum reception.
Place the AM loop antenna on a shelf, or attach it to a stand or a wall.
Notes:
z
Placing the antenna on the unit or near the AC power cord may cause noise
pickup. Place the antenna away from the unit for better reception.
z
Do not connect the attached FM antenna to an external FM antenna. Otherwise,
trouble may occur.
Installing the AM loop antenna:
< Assembling >
< Attaching to the wall >
Connecting the AC power cord
After checking all the connections have been made correctly, plug the AC
power cord of this unit into the AC outlet. If you plug the unit first, the unit
will enter the demonstration mode (see page 13).
Note:
Unplug the unit if it will not be used for a prolonged period of time.
Right speaker Left speaker
z
Use speakers with an impedance of 6 ohms or more, as lower impedance speakers
can damage the unit.
z
Do not mistake the right and the left channels. The
right speaker is the one on the right side when you face
the unit.
z
Do not let the bare speaker wires touch each other.
z
Do not allow any objects to fall into or to be placed in
the bass reflex ducts.
z
Do not stand or sit on the speakers. You may be in-
jured.
Incorrect
Black
Red
Wall Screws (not supplied)
Demonstration mode (See page 13.)