Sharp MD-MX10H Stereo System User Manual


 
18
(Continued)
Preset tuning
You can store up to 40 stations in memory (40 stations con-
sisting of any combination of AM and FM stations you like)
and recall them.
To enter stations into memory:
1 Perform steps 1 - 5 in the "Tuning" section.
2 Press the MEMORY/ENTER button.
MEMORY
3 Within 5 seconds, turn the jog dial or press the PRE-
SET (
XX
XX
X or
WW
WW
W) button to make the preset channel
number flash in the display.
Store the stations in memory, in order, starting with preset
channel 1.
When is displayed, a station has already been stored
in this preset number memory.
4 Within 5 seconds, press the MEMORY/ENTER button
to store that station in the selected station preset
number memory.
MEMORY
If the "MEMORY" and preset number indicators go out
before the station is memorised, repeat the operation from
step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in the selected station pre-
set number memory, the contents previously memorised
will be erased.
1 To scan the preset stations, press the PRESET (
XX
XX
X or
WW
WW
W) button for more than 0.5 seconds.
The station preset number will flash and the programmed
stations will be tuned in sequentially, for 5 seconds each.
2 Press the PRESET (
XX
XX
X or
WW
WW
W) button again to stop the
memory scan at the desired station.
Note:
When the preset memory does not have any stations stored
in it, the preset memory scan will not function.
To erase the memorised station:
1 Recall the memorised station to erase by turning the
jog dial or pressing the PRESET (
XX
XX
X or
WW
WW
W) button.
2 Press the CLEAR button.
"MEMORY" and preset number will flash.
3 Within 5 seconds, press the MEMORY/ENTER button.
4 Repeat steps 1-3 to erase other memorised stations.
To erase all memorised stations:
When the unit is in the stand-by mode, hold down the TUNER
(BAND) and the MD buttons, and then press the ON/
STAND-BY button.
"PRESET CLR" will appear.
To recall a memorised station:
Turn the jog dial or press the PRESET (X or W) button for
less than 0.5 seconds to select the desired station.
The stations (preset channel number, frequency and fre-
quency band) which have been stored in memory will ap-
pear in the display in numerical order, irrespective of the
frequency bands.
Backup function:
The backup function protects all station presets for a few hours
should there be a power failure or the AC power lead is re-
moved from the AC socket.
Preset memory scan
The stations saved in the preset memory can be scanned
automatically.
3
2,4
2,4
3
PRESET
(X W)
MEMORY/
ENTER
CLEAR