Sharp MD-MX10H Stereo System User Manual


 
12
MINIDISC OPERATION
1 Press the ON/STAND-BY button to turn the power on.
2 Press the MD button.
3 Load a MiniDisc in the direction indicated by the ar-
row on the MiniDisc, with the labelled side facing up.
The disc name will be displayed only when it has been
programmed.
Disc name
The total number of tracks and the total playing time on
the MiniDisc will be displayed.
Total number of tracks Total playing time
4 Press the
MD
0606
0606
06 button.
If the MiniDisc has a track name, it will appear and scroll
across the display. Then, the elapsed playing time will ap-
pear.
If the MiniDisc has no track names, the elapsed playing
time will appear.
When the last track has been played back, the unit will
stop automatically.
To interrupt playback:
Press the MD 06 button.
" 6 " will appear.
Press the MD 06 button again to resume playback from
the same point.
To stop playback:
Press the MD button.
To remove a MiniDisc:
Press the 7 button.
Caution:
Do not carry the unit with a MiniDisc left in the MD
compartment. The disc may come loose inside the unit
and it may be damaged or cause damage to the unit.
This may also cause malfunctions.
If TV or radio interference occurs when using the MiniDisc,
move the unit away from the TV or radio.
Although MiniDiscs will not normally skip due to vibration,
you may hear skipping in the sound if there is continuous
vibration.
If the volume is turned up too high, sound skipping may
occur depending on the contents of the MiniDisc.
If this happens, turn the volume down and the skipping
should stop.
If an error message is displayed during MiniDisc opera-
tion, see "ERROR MESSAGES" on page 37.
MiniDisc playback
3
1
4
2
1
4
77
77
7
2
Label side up