Filter
Top Products
08/1/15 CD-G14000_EN.fm
6
General Information
TINSEA128AWZZ
CD-G14000
Precautions
General
Please ensure that the system is positioned in a well-ventilated
area and ensure that there is at least 4" (10 cm) of free space
along the sides, top and back of the equipment.
Do not place anything on top of the unit and subwoofer.
Do not expose the system to moisture, to temperatures higher
than 140˚F (60˚C) or to extremely low temperatures.
If your system does not work properly, disconnect the AC power
cord from the AC outlet. Plug the AC power cord back in, and then
turn on your system.
This unit should only be used within the range of 41˚F - 95˚F
(5˚C - 35˚C).
Warning:
The voltage used must be the same as that specified on this unit.
Using this product with a higher voltage other than that which is
specified is dangerous and may result in a fire or other type of
accident causing damage. SHARP will not be held responsible for
any damage resulting from use of this unit with a voltage other than
that which is specified.
Volume control
The sound level at a given volume setting depends on speaker
efficiency, location and various other factors. It is advisable to avoid
exposure to high volume levels, which occurs while turning the unit
on with the volume control setting up high, or while continually
listening at high volumes. Excessive sound pressure from earphones
and headphones can cause hearing loss.
Do not place active subwoofer system on
the same surface as main unit to prevent
sound interruption during playback.
Use the unit on a firm, level surface free from
vibration.
Keep the unit away from direct sunlight,
strong magnetic fields, excessive dust,
humidity and electronic/electrical
equipment (home computers,
facsimiles, etc.) which generate
electrical noise.
4" (10 cm)
4" (10 cm) 4" (10 cm)
4" (10 cm)
TIMER
POWER
ON/ STAND-BY
CD
TUNER
(BAND)
4
3
1
5
4
5
3
2
1
PRESET
TUNING
PRESET
TUNING
VOL.
VOL.
PHONESAUDIO IN
RECORD/PLAYBACKPLAYBACK (PLAY & STOP)
REMOTE
SENSOR
2
TAPE
(1 2)
OPEN/
CLOSE
c
AUDIO
IN
Floor
In case of an electrical storm, unplug the
system for safety.
Hold the AC power plug by the head when
removing it from the AC outlet, as pulling
the cord can damage internal wires.
The AC power plug is used as a disconnect
device and shall always remain readily
operable.
Do not remove the outer cover, as this
may result in electric shock. Refer
internal service to your local SHARP
service facility.