Sharp G14000 Stereo System User Manual


 
CD-G14000
08/1/15 CD-G14000_EN.fm
35
Tape Recording
TINSEA128AWZZ
To perform programmed recording:
To stop recording:
Press the button.
The disc and tape will stop.
Recording from the radio
To interrupt recording:
Press the button.
To resume recording, press the / button.
To stop recording:
Press the button.
Note:
If you hear a whistling noise while recording an AM station, move the
AM loop antenna.
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press the button.
TAPE 1 and TAPE 2 will simultaneously stop.
Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette
compartment with the side to be erased facing toward you.
2 Press the TAPE (1 2) button until “TAPE 2” appears on the
display.
3 Press the button.
4 Press the / button to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
1 Program discs and tracks. (See page 25.)
2 Press the button.
3 Press the / button.
1 Tune in to the desired station. (See page 30)
2 Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3 Press the button.
Recording will be paused.
4 Press the / button to start recording.
1 Press the ON/STAND-BY button to turn the power on.
2 Load a prerecorded cassette
into the TAPE 1 cassette
compartment. Insert a blank
tape into the TAPE 2 cassette
compartment.
It is recommended that the recording tape is the same length as
the master tape.
3 Press the TAPE (1 2) button until “TAPE 1” appears on
the display.
4 Press the button.
Recording will be paused.
5 Press the / button to start dubbing.
TAPE 1 TAPE 2
C
D
4
3
2
1
5
P
R
E
S
E
T
T
U
N
IN
G
P
R
E
S
E
T
T
U
N
IN
G
V
O
L
.
V
O
L
.
P
H
O
N
E
S
A
U
D
IO
IN
R
E
C
O
R
D
/
PL
A
Y
B
A
C
K
P
L
A
Y
B
A
C
K
(P
L
A
Y
&
S
T
O
P
)