Filter
Top Products
CD-G14000
08/1/15 CD-G14000_EN.fm
31
Radio
TINSEA128AWZZ
Memorizing a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorized stations for a few hours
should there be a power failure or the AC power cord become
disconnected.
To recall a memorized station
To scan the preset stations
The stations saved in memory can be scanned automatically.
(Preset memory scan)
To erase entire preset memory
1 Perform steps 1 - 3 in “Tuning” on page 30.
2 Press the MEMORY button to enter the preset tuning
saving mode.
3 Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the MEMORY button to store that
station in memory.
If the “MEMORY” and preset number indicators disappear
before the station is memorized, repeat the operation from step
2.
5 Repeat steps 1 - 4 to set other stations, or to change a
preset station.
When a new station is stored in memory, the station previously
memorized for that preset channel number will be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
1 Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired
station is located.
1 Press the ON/STAND-BY button to enter the power stand-by
mode.
2 While pressing down the button and the button, press
the TUNER(BAND) button until “TUNER CL” appears.
TIMER
POWER
ON/ STAND-BY
CD
TUNER
(BAND)
4
3
1
5
4
5
3
2
1
PRESET
TUNING
PRESET
TUNING
VOL.
VOL.
REMOTE
SENSOR
2
TAPE
(1 2)
OPEN/
CLOSE
c
AUDIO
IN
PRESET
PRESET
PRESET
PRESET
PRESET
TUNER
(BAND)