Filter
Top Products
03/12/17 XL-DK227N.fm
11
XL-DK227N
Preparation for Use
Antenna connection
Supplied FM antenna:
Connect the FM antenna wire to the FM 75 OHMS jack and position
the FM antenna wire in the direction where the strongest signal can
be received.
Supplied AM loop antenna:
Connect the AM loop antenna to the AM and GND terminals. Position
the AM loop antenna for optimum reception. Place the AM loop
antenna on
a shelf, etc., or attach it to a stand or a wall with screws
(not supplied).
Note:
Placing the antenna on the unit or near the AC power cord may
cause noise pickup. Place the antenna away from the unit for better
reception.
Installing the AM loop antenna:
Speaker connection
Connect the black wire to the minus (–) terminal, and the red wire to
the plus (+) terminal.
Caution:
Connecting
iPod
to a TV
The iPod with photo and video can be viewed by connecting to a TV/
monitor.
If the TV/monitor has a video input, connect it to the VIDEO OUT jack
on the rear of the unit.
Note:
Please make sure to set iPod unit to either NTSC or PAL to match your
TV signal. Please visit Apple’s home page for futher information.
< Assembling > < Attaching to the wall >
Wall Screws (not supplied)
Use speakers with an impedance of 4 ohms or more, as lower
impedance speakers can damage the unit.
Do not mistake the right and the left
channels. The right speaker is the one on the
right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not allow any objects to fall into or to be
placed in the bass reflex ducts.
Do not stand or sit on the speakers. You may
be injured.
Red Black
Incorrect
TV
To video
input jack
Video cable
(not supplied)