Sharp CP-G10000S Stereo System User Manual


 
41
CD-G10000
CP-G10000S
References
Headphones
z Before plugging in or unplugging the headphones, reduce the
volume.
z Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
z Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOL. control.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
General
CD player
Symptom Possible cause
z
The clock is not set to the
correct time.
z
Did a power failure occur? Reset
the clock. (Refer to page 19.)
z When a button is pressed,
the unit does not respond.
z Set the unit to the power stand-
by mode and then turn it back on.
z
If the unit still malfunctions, reset
it. (Refer to page 43.)
z No sound is heard. z Is the volume level set to "0"?
z Are the headphones connected?
z Are the speaker wires discon-
nected?
Symptom Possible cause
z Playback does not start. z Is the disc loaded upside down?
z Playback stops in the mid-
dle or is not performed
properly.
z Does the disc satisfy the stan-
dards?
z Is the disc distorted or
scratched?
z Playback sounds are
skipped, or stopped in the
middle of a track.
z Is the unit located near excessive
vibrations?
z
Is the disc very dirty?
z
Has condensation formed inside
the unit?