Sharp CP-G10000S Stereo System User Manual


 
12
CD-G10000
CP-G10000S
Preparation for Use
System connections (continued)
Antenna connection
Supplied FM antenna:
Connect the FM antenna wire to the FM 75 OHMS terminal and
position the FM antenna wire in the direction where the strongest
signal can be received.
Supplied AM loop antenna:
Connect the AM loop antenna to the AM LOOP jack. Position the
AM loop antenna for optimum reception. Place the AM loop antenna
on a shelf, etc., or attach it to a stand or a wall with screws (not sup-
plied).
Note:
Placing the antenna on the unit or near the AC power cord may
cause noise pickup. Place the antenna away from the unit for better
reception.
Installing the AM loop antenna:
Speaker connection
Front speakers:
Connect the black wire to the FRONT SPEAKERS (-) terminal, and
the red wire to the FRONT SPEAKERS (+) terminal.
Rear speakers:
Connect the black wire to the REAR SPEAKERS (-) terminal, and
the gray wire to the REAR SPEAKERS (+) terminal.
Caution:
< Assembling > < Attaching to the wall >
Wall Screws (not supplied)
z Connect the speaker wires to the speakers first, then to the unit.
z
Never mistake the FRONT SPEAKERS and the REAR SPEAK-
ERS terminals. Otherwise the unit or the speakers may be dam-
aged.
z If you use other speakers with impedance lower
than that specified, the unit may be damaged.
Front speakers: 8 ohms Rear speakers: 16 ohms
z
Do not mistake the right and the left channels. The
right speaker is the one on the right side when you
face the unit.
z
Do not let the bare speaker wires touch each
other.
z Do not allow any objects to fall into or to be placed
in the bass reflex ducts.
z
Do not stand or sit on the speakers. You may be injured.
Black
Red
Front speaker (right)
Rear speaker (right) Rear speaker (left)
Front speaker (left)
Gray
Incorrect
Incorrect