Filter
Top Products
Adjustment tips for the operating menu
24
Activating/deactivating the automatic lock mode – “LOCK”
The transmitter has an autolock function (automatic lock mode) that can be activated or
deactivated via the “LOCK” menu. When the autolock function is activated
, the lock mode is
automatically activated 10 seconds after pressing the last button. The lock mode protects the
transmitter from accidental programming.
Adjusting the output power – “POWER”
The transmitter features switchable output power. With reduced output power, the operating
time increases.
In addition, you can also adjust the transmitter to “Low Intermodulation mode” (“LoI”). By so
doing, the transmitter’s intermodulation performance is significantly improved, especially in
multi-channel operation. In “Low Intermodulation mode”, the output power is reduced to
10
mW; the operating time will be about the same as using an output power of 50 mW.
Displaying the software revision – “SW--REV“
You can display the current software revision of the bodypack transmitter by calling up the
“SW-REV“ menu item.
̈ In the selection mode of the “LOCK” menu, press the multi-function
switch ¾ (switch position țSET).
The current setting of the autolock function is displayed.
̈ Change the setting by sliding the multi-function switch ¾ to the
position ̆ (UP) or ̄ (DOWN).
Select “LOC.ON” to activate the autolock function or select “LOC.OFF”
to deactivate the autolock function.
̈ Store your setting by pressing the multi-function switch ¾ (switch
position țSET)
.
SET
DOWN
UP
¾
RF
RF